DISPLAY PROCESS CHAIN STATUS - USAP Command
Description
The DISPLAY PROCESS CHAIN STATUS command displays the current status of the process chain. The exit code will reflect the status.
Note
This command requires the SAP system to calculate the status of each process within the process chain. For complex chains, the command can put load on the system if called with high frequency.
Command Line Syntax
The following figure illustrates the command line syntax of the DISPLAY PROCESS CHAIN STATUS command, using the command line, long form of its configuration options.
Command Argument
The DISPLAY PROCESS CHAIN STATUS command can be expressed as either:
- -D (Short form)
- -display (Long form)
The DISPLAY PROCESS CHAIN STATUS command argument, status, requests the display of the current status of the process chain.
Configuration Options
The following table describes all DISPLAY PROCESS CHAIN STATUS configuration options and provides the command line, long form of each option illustrated in the DISPLAY PROCESS CHAIN STATUS command line syntax, above.
Configuration | Command Line | Description |
|---|---|---|
-chainid | ID of process chain whose status is to be displayed. | |
-logid | Log ID of process chain instance whose status is to be displayed. |
Output
- stdout: Statement indicating the status of the process chain.
- stderr: UNV messages.
Exit Codes
Use exit code mappings:
- 'R' - Red: pcredec.
- 'G' - Green: pcgreenec.
- 'X' - Aborted: pcabortedec.
- 'A' - Active: pcactiveec.